Mon, Sep 23, 2019

Prof. Swarup Kumar Ghosh, Department of Metallurgy and Materials Engineering

Dr. Swarup Kumar Ghosh
Dr. Swarup Kumar Ghosh   Dr. Swarup Kumar Ghosh
Professor ,   Metallurgy And Materials Engineering

  • Ph. D., 2007, Bengal Engineering and Science University, Shibpur.
  • M.E. (Met), 1995, B. E. College (D.U.).
  • B.E. (Met), 1993, Calcutta University.

 

Contact Addresses
Residence Flat No. A-3, 3/4, Madhusudan Das Lane,
Howrah-711 103, West Bengal, India
Phone (office) +91 - 33 - 26684561/62/63 Ext. 460
Mobile
email This e-mail address is being protected from spambots. You need JavaScript enabled to view it , This e-mail address is being protected from spambots. You need JavaScript enabled to view it , This e-mail address is being protected from spambots. You need JavaScript enabled to view it

 

Research Areas
  • Phase Transformation.
  • Ferrous and non-ferrous alloys.
  • ANN modelling study.

 

Recent Publications
  • S.K.Ghosh and S.Chatterjee, 2000, Development of Diffusion Bonded Joints of Ti-6Al-4V and 304L Stainless Steel, Abstracts Vol. of 7th West Bengal State Science and Technological Congress, J.U., Calcutta – 32., Abstracts Vol. of 7th West Bengal State Science and Technological Congress, 3, MMM -9.
  • S. K. Ghosh, D. Das and P. P. Chattopadhyay: Structure Property Correlation of Ti, B Microalloyed Dual Phase Steels, Journal of the Institution of Engineers (India), Vol. 82, No. MM/2, (2001), pp. 50 - 57.
  • S. K. Ghosh, A Samanta and P. P. Chattopadhyay: Effects of Ageing Treatment on the Microstructure and Mechanical Properties of Cu - added Ti, B Microalloyed Steels, Transactions of the Indian Institute of Metals, Vol. 57, No. 2, 2004, pp.171 –180.
  • S. K. Ghosh, N. R. Bandopadhyay and P. P. Chattopadhyay: Effects of Finish Rolling Temperature on the Microstructures and Mechanical Properties of as Hot Rolled Cu – added Ti, B Microalloyed Dual Phase Steels, Journal of the Institution of Engineers (India), Vol. 85, No. MM/2, 2004,  pp. 41- 48.
  • S. K. Ghosh, S. Ganguly, P. P. Chattopadhyay and S. Datta: Modelling the Effect of Copper on Hardness of Microalloyed Dual Phase Steel through Neural Network and Neuro-fuzzy Systems, ISIJ International, Vol. 45, No. 9, 2005, pp. 1345 – 1351.
  • S. K. Ghosh, A. Haldar and P. P. Chattopadhyay: Dilatometric studies on copper added titanium – boron steels; Steel Research International 78 (2007) pp. 903- 907.
  • S. K. Ghosh, A. Haldar and P. P. Chattopadhyay: Effect of pre - strain on the ageing behaviour of directly air – cooled copper added titanium – boron microalloyed steels; Materials Science and Technology 23 (2007) pp. 923-929.
  • S. K. Ghosh, A. Haldar and P. P. Chattopadhyay: Effect of copper additions in directly quenched titanium – boron steels; Journal of Materials Science 42 (2007) pp. 9453-9459.
  • S. K. Ghosh, A. Haldar and P. P. Chattopadhyay: Mechanical properties of directly air cooled copper added microalloyed steels; Materials Science and Technology 23 (2007) pp.1375-1380.
  • S. K. Ghosh and S. Mondal: Effect of heat treatment on microstructure and mechanical properties of duplex stainless steel; Transactions of the Indian Institute of Metals 61 (2008) pp. 33-37.
  • S. K. Ghosh, S. Ganguly, P. P. Chattopadhyay and S. Datta: Determination of MS temperature in copper bearing microalloyed steel by the ANN technique; Canadian Metallurgical Quarterly 47 (2008) pp.91-97.
  • S. K. Ghosh, A. Haldar and P. P. Chattopadhyay: Effect of pre - strain on the ageing behavior of directly quenched copper containing microalloyed steel; Materials Characterization 59 (2008) pp. 1227-1233.
  • S. K. Ghosh and S. Mondal: High temperature ageing behavior of a duplex stainless steel; Materials Characterization 59 (2008) pp. 1776-1783. 
  • S. K. Ghosh, A. Haldar, S. Ganguly and P. P. Chattopadhyay: Development of high strength Cu – Ni - Ti - B multiphase steel by direct air – cooling; Metallurgical and Materials Transactions A 39A (2008) pp. 2555-2568.
  • S. K. Ghosh, P. P. Chattopadhyay, A. Haldar, S. Ganguly and S. Datta: Design of the directly air – cooled pearlite - free multiphase steel from CCT diagrams developed using ANN and dilatometric methods; ISIJ International 48 (2008) pp. 649-657.
  • S. K. Ghosh, A. Haldar and P. P. Chattopadhyay: The influence of copper addition on microstructure and mechanical properties of thermomechanically processed microalloyed steels; Journal of Materials Science 44 (2009) pp. 580-590. 
  • S. K. Ghosh, S. Ganguly, P. P. Chattopadhyay and S. Datta: Effect of copper and microalloying (Ti, B) addition on tensile properties of HSLA steels predicted by ANN technique; Ironmaking and Steelmaking 36(2009) pp. 125-132.
  • S. K. Ghosh, A. Haldar and P. P. Chattopadhyay: On the copper precipitation behaviour in thermomechanically processed low carbon microalloyed steels; Materials Science and Engineering A, 519 (2009) pp. 88- 93.
  • S. K. Ghosh, N. Bhowmik, A. Haldar and P. P. Chattopadhyay: Effects of Cu addition on the synergistic effects of Ti - B in thermomechanically processed low carbon steels, Materials Science and Engineering A, A527 (2010) pp. 1082-1088. 
  • S. K. Ghosh, A. Haldar and P. P. Chattopadhyay: Effect of ageing on the mechanical properties of directly quenched copper bearing microalloyed steels, Materials Chemistry and Physics, 119 (2010) pp. 436-441. 
  • H. L. Yi, S. K. Ghosh, W. Liu, K. Lee and H. K. D. H. Bhadeshia: Non-equilibrium solidification and ferrite in -TRIP steel, Materials Science and Technology, 26 (7) (2010) pp. 817- 823.
  • S. K. Ghosh and S. Chatterjee: On the direct diffusion bonding of titanium alloy to stainless steel, Materials and Manufacturing Processes, 25 (2010) pp. 1317–1323. 
  • S. K. Ghosh, P. Mallick and P. P. Chattopadhyay: Effect of reversion of strain induced martensite on microstructure and mechanical properties in an austenitic stainless steel, Journal of Materials Science, 46 (2011) pp. 3480-3487. 
  • P. S. Bandyopadhyay, S. Kundu, S. K. Ghosh and S. Chatterjee, Structure and properties of a low-carbon, microalloyed, ultra-high-strength steel, Metallurgical and Materials Transactions A, 42A, (2011) pp. 1051-1061.
  • S. K. Ghosh: Influence of cold deformation on the aging behaviour of Al-Cu-Si-Mg alloy, Journal of Materials Science and Technology, 2011, 27(3), pp. 193-198. 
  • N. Bhowmik, S. K. Ghosh, A. Haldar and P. P. Chattopadhyay: High strength low carbon hot rolled -ferritic steel: microstructure and mechanical properties, Materials Science and Technology 27 (11) (2011) pp. 1718-1723. 
  • P. S. Bandyopadhyay, S. K. Ghosh, S. Kundu and S. Chatterjee: Evolution of microstructure and mechanical properties of thermomechanically processed ultrahigh strength steel, Metallurgical and Materials Transactions A, 42A (2011) pp. 2742- 2752. 
  • S. Chatterjee, S. K. Ghosh, P. S. Bandyopadhyay and Sanak Mishra: Phase transformation and mechanical properties of an ultrahigh strength steel, Journal of Iron and Steel Research International, 18, (Supplement 1-1) (2011) pp. 192-199. 
  • N. Bhowmik, S. K. Ghosh, A. Haldar and P. P. Chattopadhyay: Low carbon high manganese bainitic steel, Materials Science and Technology (2011) Article in Press. 
  • S. K. Ghosh, P. Mallick and P. P. Chattopadhyay: Effect of Cold Deformation on Phase Evolution and Mechanical Properties in an Austenitic Stainless Steel for Structural and Safety Applications, Accepted in Journal of Iron and Steel Research International, 2011. 
  • S. K. Ghosh, P. S. Bandyopadhyay, S. Kundu and S. Chatterjee: Copper bearing microalloyed ultrahigh strength steel on a pilot scale: microstructure and properties, Materials Science and Engineering A, 528 (2011) pp. 7887-7894. 
  • S. K. Ghosh, Shikhar, P. Mallick and P. P. Chattopadhyay: Influence of Mechanical Deformation and Annealing on Kinetics of Martensite in a Stainless Steel, Accepted in Materials and Manufacturing Processes, (2011).
  • S. K. Ghosh, D. Mahata, R. Roychaudhuri and R. Mondal: Effect of rolling deformation and solution treatment on the microstructure and mechanical properties of a cast duplex stainless steel, Accepted in Bulletin of Materials Science (2011).  
  • S. K. Ghosh, and P. P. Chattopadhyay: Effect of Minor Cu - Addition on Microstructural Evolution in Ti, B Microalloyed Dual Phase Steel, Asia Steel International Conf. Proc. (2003), Tata Steel, Jamshedpur, India, Vol. 3, 2003, pp. 3.c.4.1- 3.c.4.8.
  • S. K. Ghosh and P. P. Chattopadhyay: Microstructural Evolution in Cu - added Ti, B Microalloyed Dual Phase Steel, Proc. Int. Conf. on Advances in Materials & Processes for Industrial Applications and Materials Show 2003, ASM International, Pune Chapter, Pune, India, 2003, Technical Vol., pp. 35 – 42.
  • S. K. Ghosh, A. Haldar and P. P. Chattopadhyay: Effect of Cu Addition in Multiphase Ti, B Microalloyed Steel, Proc. Int. Conf on Advances in Materials and Materials Processing, IIT Kharagpur, 2006, pp. 551-558.
  • S. K. Ghosh, P. Pal, P. P. Chattopadhyay and S. Datta: ANN Model for Assessment of MS Temperature in copper added Ti, B Microalloyed Steel, Proc. Int. Conf. on Advances in Materials and Materials Processing, IIT Kharagpur, 2006, pp. 559-566.
  • S. K. Ghosh, S. Ganguly, S. Datta, A. Haldar and P. P. Chattopadhyay: Design of Pearlite Free Air - Cooled Cu – added Ti, B Microalloyed Steel Using ANN prediction of CCT Diagrams, Proc. Int. Workshop on Neural Network and Genetic Algorithm in Materials Science and Engineering, BESUS, 2006, pp. 397 – 411.
  • S. K. Ghosh: Effect of Pre-strain on the natural and artificial ageing behaviour of 2014 aluminium alloy, Proc. Int. Conf. on Recent Advances in Materials and Material Processing, PSG College of Technology, Coimbatore, 2006, pp. 1-5.
  • S. K. Ghosh, A. Haldar and P. P. Chattopadhya: Ageing Behaviour of Directly Quenched Copper Added Titanium - Boron Microalloyed Steels, Proc. Int. Conf. on Microalloyed Steels: Emerging Technologies and Applications, Kolkata, 2007, pp. 298 – 305.
  • S. K. Ghosh, S. Ganguly, P. Pal, A. Haldar and P. P. Chattopadhyay: Cu – Ni - Ti – B Multiphase Steel, Proc. Int. Conf. on Microalloyed Steels: Emerging Technologies and Applications, Kolkata, 2007, pp. 269 – 280.
  • N. Bhowmik, S Das, S. K. Ghosh, P. P. Chattopadhyay and A. Haldar: Evolution of microstructures and properties in a high Mn bainitic steel, International Conference on High Manganese Steels, May 15-18, Seoul, South Korea, 2011.
  • N. Bhowmik, S. Das, S. K. Ghosh, P. P. Chattopadhyay and A.Haldar: Development of low carbon high strength high ductility steel, International Conference on High Manganese Steels, May 15-18, Seoul, South Korea, 2011.


Courses Undertaken

 


Department of Metallurgy And Materials Engineering , BESU, Shibpur - 7111 03, INDIA